2002 Ford Explorer Fuse Box Diagrams (2024)

FAQs

Where is the fuse layout? ›

The main fuse box is typically located under the hood, while secondary fuse panels might be inside the car, often near the dashboard or steering wheel. The fuse's wire conductor breaks when the current exceeds the ampere limit, which manufacturers usually define along with different color codes on each fuse.

After looking at the wiring circuit, There is no specific fuse for the door alarm ajar switch; these switches are built into the door latch; it will need to be repaired or replaced to make it quit sounding that warning, unfortunately. You have one on each door and one on the liftgate.

On the 2002 Explorer ther is only one Central junction box listed and that is under the dash on the left side. The fuse panel and CJB are one and the same. the battery saver relay is the third small relay down in the bunch of 3 in the middle of the box.

The secondary under-hood fuse box is next to the battery. To open it, push the tabs as shown. If something electrical in your vehicle stops working, check for a blown fuse first. Determine from the chart on pages and , or the diagram on the fuse box lid, which fuse or fuses control that device.

Fuses are typically colour-coded to indicate their amperage rating, and the amperage rating is also usually printed on top of the fuse.

There is not an official way to disable the door ajar alarm on the Ford Explorer. What You can do is open the dash board of the car, and locate the module that controls it and pull it out. If this sounds like to much work You can also find the fuse that powers it and then pull it.

Depending on the type of vehicle you have, your door ajar light can come on for any number of reasons: An electrical short in the dome light. An electrical short in the anti-theft system. A door switch stuck in the “open” position.

There are two fuse boxes in Your 2002 Ford Explorer. The main fuse relay box is located on the left inner fender well under the hood. The auxiliary fuse/relay block is located under the driver's side instrument panel.

Engine fuse boxes are typically situated near the battery. In this vehicle, the battery is on the driver's side, and there is a fuse box right above it with a black plastic cover to protect the fuses. On the passenger side, there is also a battery, and the fuse box is located nearby.

Where is the BCM on a Ford Explorer? ›

At the BCM, located under the instrument panel, to the left of the steering column, remove the BCM fuse 35 (5A). Refer to Wiring Cell 11 Fuse and Relay Information for schematic and connector information. 4. Turn the ignition ON and monitor the air bag warning indicator for at least 30 seconds.

There are two fuse boxes, one located near the engine or under the hood and the other is located near the driver seat. The car fuse box under the hood protects engine components including engine control unit (ECU), cooling fan, ABS motor and battery.

A switched fuse is one that only has power when the ignition is turned on, while a constant fuse always has power.

Most vehicles are equipped with two fuse boxes.

Fuse boxes are commonly found in utility rooms, porches or under-the-stairs cupboards. You may also have one in your hallway or garage. Wherever your fuse board is located, you must have easy access to it. Make sure you keep the area surrounding your fuse box clear from clutter.

The best place to install a fuse in a grounded power system is on the ungrounded conductor path to the load. That way, when the fuse blows there will only be the grounded (safe) conductor still connected to the load, making it safer for people to be around.

The fuse is placed in the live wire just after the 'electricity meter' of the consumer. Fuse wires are generally made of an alloy of tin and lead and have a relatively low melting point.